Operating manual - English
DELTA 2000 MC
Copyright Silca 1 998
9
5
MACHINE INSTALLATION AND PREPARATION
The DELTA 2000 MC key-cutting machine can be installed by the purchaser and does not require any
special skills. However, some checks and preparation for use need to be carried out by the operator.
5.1
Checking for damage
The DELTA 2000 MC is solid and compact and will not normally damage if transport, unpacking and in-
stallation have all been carried out according to the instructions on the packing box.
However, it is always advisable to check that the machine has not suffered any damage.
5.2
Environmental conditions
To ensure that the best use is m ade of the key-cutting machine, certain parameters must be borne in
mind:
- damp, badly ventilated sites should be avoided.
- the conditions for the machine are:
- temperature: between 0 and 40°C
- relative humidity: approx. 60%
5.3
Positioning
Place the machine on a horizontal surface, solid enough to take the weight (14 Kg).
To facilitate operation and maintenance, install the machine with a clearance of at least 200 mm on all
sides (fig. 7).
Check that the weight of the machine is evenly distributed over the four feet; horizontal positioning pre-
vents vibrations during operation.
WARNING:
ensure that the machine voltage is the same as that of the mains, which must be properly earthed
and provided with a differential switch.
Fig. 7
200 m
m
Summary of Contents for Delta 2000 MC
Page 4: ......
