DELTA 2000 MC
Operating manual - English
12
Copyright Silca 1 998
6.3
Cutting operations
WARNING:
to work in complete safety, pay special attention to the following recommendations:
•
Always work with dry hands.
•
Check that the machine is properly earthed.
•
Use the protective goggles, even if the cutting tool is fitted with a protective shield.
•
Start the motor only when all the operations with the carriage have been carried out (securing
keys, etc.).
•
Keep hands away from the cutting tool when in motion.
6.4
Replacing the tip stop
ABLOY keys can feature two types of cut which differ only in the dis-
tance between the first cut and the tip of the key. This distance can
be 3 or 5 mm (fig. 12). The machine leaves our workshops set for
the cutting of ABLOY keys with a distance of 5 mm between the tip
and the first cut. To cut keys wit h a distance of 3mm the standard
tip stops must be replaced with the ones provided.
Fig. 12
To do so, proceed as follows:
1) loosen the two grub screws (C1);
2) remove the 5 mm tip stops;
3) fit the 3 mm tip stops provided, positioning them as shown in fig. 13;
4) tighten the grub screws (C1), exerting slight pressure in the direction of the arrow on the tip stops.
F
ITTING
KEYS
INTO
THE
CLAMP
ABLOY
-
FO
19
P
/
FO
20
P
:
Place the original key in the left-hand jaw, pushing towards the tip stop and secure by means of the knob
(B1); the profile of the jaw ensures that the key is centred. Place the key blank in the right-hand jaw in
the same way and secure by means of the knob (A1).
AB
32 -
AB
38
P
:
Place the original key in the left-hand jaw (B), pushing towards the tip stop and against the side of the
jaw (fig. 13); secure by means of the knob (B1). Place the key blank in the right-hand jaw (A) in the same
way and secure by means of the knob (A1).
Fig. 13
C
A
B
A1
B1
original
key
key
blank
A1
B1
C
C
C1
C1
B
A
Summary of Contents for Delta 2000 MC
Page 4: ......
