Operating manual - English
DELTA 2000 MC
Copyright Silca 1 998
13
K
EY
CUTTING
1) Fit the original key into the left-hand jaw (B) and secure in the way described above;
2) fit the key blank into the right-hand jaw (A) and secure in the way described above;
3) activate the machine by means of start button (F);
4) grip the lever (D1) with the left hand and the knob (A1) with the right hand;
5) push the carriage towards the cutting tool until it brings the original key int o contact with the tr acer
point;
6) make a rotary movement downwards with the knob (A1) to copy the inclination of the cuts;
7) repeat the operation for each cut, if necessary adding a slight horizontal movement (fig. 14);
8) for keys cut on both sides, turn off the machine and turn both keys over, then repeat the operations
described above;
9) when cutting is finished, turn off the machine and remove the keys from the clamp;
10) re-activate the machine with switch (F) and eliminate burrs with the brush (K).
Fig. 14
original key
key blank
A
B
B1
A1
D1
A1
Summary of Contents for Delta 2000 MC
Page 4: ......
