Easy Scan
Plus
English
11
Copyright Silca S.p.A 2016
Note:
This func on responds only with Silca remote controls.
If remote controls by another manufacturer are used, the
Easy Scan Plus display will show:
Copy check
NOT SILCA REMOTE
Verify again?
(ESC) NO (ENT) YES
If the remote control cannot be copied the Easy Scan Plus
display will show the following message:
Identi
fi
cation
Not copyable remote
433 MHz
(ESC) main menu
IDENTIFICATION / COPY OF A QUARTZED REMOTE CONTROL
The “Iden
fi
ca on” and “Check Copy” func ons for quartzed remote controls is the same as that for
fi
xed
code ones.
Before star ng a copy check procedure, Easy Scan Plus requires the intensity of the signal from the copied
remote control to be tuned:
Open the remote control case (see remote control instruc-
ons).
Take the quartzed remote control up to the reading area (to
make contact see
fi
gure 1), hold down any bu on.
Use the ceramic screwdriver to slowly turn the antenna
adjus ng screw to achieve maximum band on the intensity
indicator on the display.
When the maximum value is reached, move the remote
control a li le farther away and repeat the opera on un l
the maximum visible on the display is reached.
Close the remote control case.
Antenna Tuning
0 | 50 | 100
Press remote button
(ESC) back (ENT) Next
OTHER EASY SCAN PLUS FUNCTIONS
CHECK COPY FUNCTION
Use the bu ons on the side of the display to select “Check
Copy”.
Press “ENTER” to con nue.
Main menu
Identi
fi
cation
> Copy check
Frequency meter
Antenna Tuning
Options
(ENT) to continue
Take the original remote control up to the reading area (to
make contact see
fi
g.1) and press any bu on on the remote
control.
Copy check
Press any key
on original Remote
(ESC) main menu
