Easy Scan
Plus
Copyright Silca S.p.A 2016
English
12
Only in the case of Rolling Secure Learning remote
control
The user is required to send the source code for the remote
control to be copied; how to send it depends on the remote
control involved. Check with website www.silca.biz to see
which way is indicated for your remote control.
Copy check
Waiting for
SOURCE code
Wait Remote
433 MHz
(ESC) main menu
Only in the case of quartzed remote control
To make copy checking for quartzed remote controls more reliable and precise, we recommend using the
“Tuning Antenna” func on to read the intensity of the copied remote control signal.
When required, take the copied Silca remote control up to
the reading area (to make contact see
fi
gure 1) and press
any bu on on the remote control.
Identi
fi
cation
Press the same key
on copied Remote
(ESC) main menu
If the copied remote control is the same as the original,
Easy Scan Plus will show the message:
Copy check
SUCCESSFUL copy
433 MHz
(ENT) to continue
Otherwise:
Copy check
WRONG copy
not matching code
433 MHz
(ENT) to continue
Note:
This func on responds only with Silca remote controls.
If remote controls by another manufacturer are used, the
Easy Scan Plus display will show:
Copy check
NOT SILCA REMOTE
Verify again?
433 MHz
(ESC) NO (ENT) YES
FREQUENCY METER:
Use the bu ons on the side of the display to select
“Frequency meter”.
Press “ENTER” to con nue.
Main menu
Identi
fi
cation
Copy check
> Frequency meter
Antenna Tuning
Options
(ENT) to continue
