Operating manual - English
SMARTY 2000
19
8
MAINTENANCE
Although the SMARTY 2000 key-cutting machine does not require special maintenance, it is advisable
to check and, if necessary, replace the parts subject to wear, such as: the belt, cutting tool, brush, tracer
point. Replacement is simple and can be carried out by the operator.
CLEANING
: keep the carriage and clamps free of chippings from the cutting operations by cleaning with
a dry brush.
ATTENTION: do not use compressed air!
Before starting any type of maintenance (checks or replacements), read the instructions below:
•
never carry out maintenance or servicing with the machine switched on.
•
always remove the mains plug.
•
follow all the instructions in the manual to the letter.
•
use original spare parts.
•
always check that any screws or nuts removed when replacing a piece are properly
tightened.
8.1
Replacing the cutting tool
In order to substitute the cutting tool you don’t need to remove the cutting tool cover (F1) (fig.4, page 8).
ATTENTION: remove the mains plug.
1) slot the locking rod (standard) into the hole of the cutting tool shaft (fig.13).
2) use the spanner provided to loosen the cutting tool locking nut.
ATTENTION: the thread is left-handed.
3) remove the worn cutting tool.
4) carefully clean the new cutting tool and its seat.
5) install the new cutting tool and tighten the nut.
ATTENTION: the tool rotates clockwise.
6) remove the locking rod.
Fig. 13
8.2
Replacing the brush
When the brush (E) no longer cleans off the burrs it must be replaced as follows:
ATTENTION: remove the mains plug.
1) remove the motor cover (E1) by loosening the screws (E2) (fig.4, page 8).
2) place the spanner provided in position on the motor shaft.
3) use the Allen wrench to loosen the screw holding the brush (E) in place.
4) replace the brush (E) and tighten the screw with the Allen wrench.
5) remove the spanner from the motor shaft.
6) place the motor cover (E1).
locking rod
Summary of Contents for Ilco Orion SMARTY 2000
Page 1: ... D430568XA vers 3 0 Operating manual SMARTY 2000 ...
Page 4: ......
