3 MACHINE INSTALLATION AND PREPARATION
Installation is the customer’s task and does not require any special skills.
The key-cutting machine is supplied ready for use and does not need calibration; however, the operator is required
to make certain checks and prepare the machine for use.
3.1 CHECKING FOR DAMAGE
POKER PRO is a solid compact machine and will not break if handling, unpacking and installation are carried out
to the instructions in this manual. However, it is good practice to check that the machine has not been damaged.
3.2 ENVIRONMENTAL CONDITIONS
To make the most of the key-cutting machine, bear in mind the following environmental parameters: it is advisable
for the area to be dry with good air circulation.
The optimum environmental conditions for machine operation are:
-
temperature 10° C to 40°C; - relative humidity: approx 60%.
3.3 POSITIONING
1) Place the key-cutting machine on a solid horizontal work bench suitable for the weight of the machine (
16
Kg). The work bench should be approximately 100-120 cm high to facilitate access to the working parts. We
recommend leaving at least 30 cm clearance behind and around the machine to ensure good ventilation and
facilitate handling (Fig. 8).
2) Make sure machine voltage is suitable for the mains supply and that the latter is earthed with a differential
switch.
3) Connect the power lead (power pack) to the machine (Ch.3.4.1).
100/120 cm
30 cm
30 cm
30 cm
Fig. 8
Operating manual
POKER PRO
Copyright Silca 2019
10
