UM-FULL-30SL rev A
6
ANTI CAR- JACKING (Programmable)
Warning:
If you don’t need the carjacking function in this alarm system, be sure to set carjacking feature
“OFF”
.
This systems default setting is
“OFF”
for all carjacking modes.
ACTIVE ANTI CAR JACKING
1. Under ignition
“ON”
, press and hold the and buttons at the same time for 2 seconds. The parking lights
will turn on for 1.5 seconds to indicate the system has entered the anti car-jacking mode.
2. Once the system is in anti car-jacking mode, the system will be triggered when any door is opened and closed
while the ignition is
“ON”
.
PASSIVE ANTI CAR- JACKING (Programmable)
Will operate as noted below:
1. Turn the ignition switch to the
“ON”
position and the system will arm.
2. Once the system is armed, if you are forced from the vehicle, the system will trigger when the door is
opened and closed while the ignition is
“ON”
.
TRIGGERING THE ANTI CAR-JACKING MODE
A). 50 seconds after the system has been triggered. The siren will start chirping for 15 seconds.
B). During this 15 second period of chirping, you will be alerted to push the valet switch once to turn off
the car-jacking feature. If not, it will enter a second timer for carjacking.
C). 65 seconds after the system has been triggered, the horn or optional siren will start sounding and the
parking lights will start flashing.
D). 90 seconds after the system has been triggered,
1. The horn or optional siren will sound and the parking lights will flash, and
2. The starter disable will activate to prevent the vehicle from starting.
3. It will remain active until the vehicle’s battery power is exhausted.
OVERRIDE THE SYSTEM TO TURN OFF ANTI CAR- JACKING
Turn the ignition switch from
“OFF”
to
“ON”
and within 10 seconds push the valet switch,
the horn or optional siren will stop and the system will be disarmed.
Note
: If you use password pin code to double protect the vehicle security, you will need to
use it to completely disarm the system.
IGNITION CONTROL DOOR LOCK/UNLOCK (Programmable Feature)
If the vehicles door locks have been interfaced to the security system, the system will automatically lock the vehicle’s
doors when the ignition is turned
“ON”
and /or unlock the vehicle’s doors when the ignition is turned
“OFF”
.
(Default setting is
“OFF”
)
TRUNK RELEASE, (CHANNEL 3) OUTPUT
Press and hold the
button on the transmitter for three seconds to remotely control the trunk release.
