UM_FULL_55SL_REV_A
13
Table 4: Remote Start Quick Feature Programming
ENTER: Press & hold “ F “ button until 3 beeps are heard then release;
LCD displays flashing icon first, press and release “F” button to move blinking cursor to the
desired icon that you want to program.
Press the button to enable the feature.
Note:
Cursor method: a constant illumination means the selected feature is enabled.
Exit
: Press & hold “ F “ button for 2 seconds or do nothing wait for 5 seconds for automatic exit.
(1 beep) = Confirm Exit.
F
Button
LCD display
•
Button
Press and hold the “F”
Button until
3
beeps have
sounded
3 - 1
Icon flashing
Press button to enable
Turbo Timer mode.
icon flash = Enable
Icon Off = Disable
Press & Release “ F”
button to move cursor
flash to Daily Start icon
3 – 2
then 24H
No Setting
No Setting Available
Press & Release “ F”
button to move cursor
flash to TIMER START
icon
3 – 3
Timer Start icon Flashing
Press button to enable
Timer Start mode.
Icon On = Enable
Icon Off = Disable
E. TIMER START:
Timer Start:
Your Silencer System can be programmed to start and run the engine every 3 / 2
hours depending on the initial setup programming (Default timing is 3 hours).
IMPORTANT
: Timer Start should be used only in open areas, never start and run the vehicle in an
enclosed space such as a garage or carport.
TIMER START:
Enter:
1. Turn the Ignition key On then Off
2. Within 15 seconds, press and hold the “
F
” button on the LCD remote until 3 beeps sound.
Release and press the “
F
” button (2) more times until the LCD displays the icon flashing.
Press button to activate Time Start. The icon will illuminate on LCD display, parking light will
flash and siren chirps 3 or 2 times to confirm. The vehicle is now programmed to start every 3 or 2
hours. (Default setting is 3 hours (3 light flashes, 3 horn chirps) unless programming was changed)
Exit:
Turn the Ignition On (LED and parking light flash 4 times, and siren chirp 4 times confirm exit
Timer Start). Press the or button to turn off icon on 2-way remote.