IM_FULL_55SL_REV_B
12
WHITE / RED WIRE – TACHOMETER SIGNAL CONNECTION –
Note: You should connect this wire if you program the Start Feature D – 2 to “Tachometer checking type”,
otherwise do not connect this wire and tape the end.
Note:
No connection of this wire is required, if you use the voltage or timer checking type mode.
This input provides the remote start system with information about the engine’s revolutions per minute (RPM). It can be
connected to the negative side of the coil in vehicles with conventional coils. In multi-coil and high energy ignition systems,
locating a proper signal may be more difficult.
To test for a tachometer wire, a multi-meter capable of testing AC voltage must be used. The tachometer wire will show
between 1V and 6V AC at idle, and will increase as engine RPM increases. In multi-coil ignition systems, the system
can learn individual coil wires. Individual coil wires in a multi-coil ignition system will register lower amounts of AC voltage.
Also, if necessary, the system can use a fuel injector control wire for engine speed sensing. Common locations for a
tachometer wire are the ignition coil itself, the back of the gauges, engine computers, and automatic transmission computers.
IMPORTANT! Do not test tachometer wires with a test light or logic probe. The vehicle will be damaged.
How to find a tachometer wire with your multi-meter
1. Set the ACV or AC voltage (12V or 20V is fine.)
2. Attach the (-) probe of the meter to chassis ground.
3. Start and run the vehicle.
4. Probe the wire you suspect of being the tachometer wire with the red probe of the meter.
5. If this is the correct wire, the meter will read between 1V and 6V.
IMPORTANT NOTE: No initial programming necessary. Default = voltage sensing mode
TRANSMITTER PROGRAMMING
Enter:
1. Turn the Ignition ‘switch
“OFF/ON” 3 times
and stay in
ON
position. Within 15 seconds.
2. Push the Valet switch
3 times and hold
in on the
3rd
push. When a long chirp is heard, release the valet switch.
You are now in the Transmitter programming mode.
Program:
1. Press any button on transmitter once until the siren responds with a confirming chirp;
the first transmitter is now programmed.
2. Press any button on the second transmitter until the siren responds with a confirming chirp;
the second transmitter is now programmed.
3. Apply the same procedure to program 3rd and 4th transmitters.
Exit:
Turn Ignition to
“OFF”
position, or leave it for 15 seconds. 3 long chirps and 3 parking light flashes will confirm exit.
Note:
If more than 4 transmitters programmed, the system will only keep the last four.
