UM_FULL_56SL_REV_A
11
C.
Running Time Extender
User Programmable Run Time / Run Time Extension. The system has the ability to allow the user to extend the time
the vehicle will be running under control of the remote start. This will only extend the run time back to the current run
time setting during the current remote start cycle. If your system is set to run 20 minutes and the time remaining is
4 minutes, extending the run time will reset the countdown timer to 20 minutes and your vehicle will continue to run
for another 20 minutes. Follow the steps below to extend the vehicle’s run time.
1. The remote start must already be active.
2.
Press and hold the button for 2 seconds
3. The system will chirp 1 time and flash the parking lights 4 times and the run time
Restart
the countdown
text and tones play to confirm the run time has been reset and will indicate a countdown timer based on the 3, 10,
20, 30 or
45 minutes run time.
D. Operate The Vehicle While Running From The Remote Start
To operate the vehicle while the engine is running from the remote start:
1.
Insert the ignition key and turn it to
“ON”
(not the start) position
2.
Press the brake pedal.
Note:
If the brake pedal is pressed before the key is in the
“ON”
position, the engine will shut down.
E. Temporary Stop Mode:
This mode allows the vehicle to remain running after the key has been removed from the ignition.
This feature is useful for occasions when you wish to exit and lock the vehicle for short periods
of time but would like to leave the motor running and the climate control on.
1.
While the vehicle is running, place the transmission in PARK, set the emergency / parking brake.
2. With your foot off the brake pedal, press the button once, the parking lights will turn on and the run time start
countdown
text and tones play to confirm that the system has entered Temporary Stop Mode.
3.
Remove the keys from the ignition and exit the vehicle. Press the button to lock the vehicle’s doors if desired.
Note:
Do not leave children or animals unattended in the vehicle when using the temporary stop feature.
F. To Turn Off the Remote Start
When the engine is running (by remote start) and you want to stop it:
1. Press the button once on the remote transmitter under the remote start mode.
2.
Move the optional remote start enable toggle switch to the
“OFF”
position. (If installed)
3.
Press the brake pedal.
4.
Pull down the hand brake. (For Turbo Timer Mode)
The vehicle will shut down and turn off the parking light and the
icon will disappear and
tones play to confirm the engine has stopped.
Summary of Contents for 56SL
Page 1: ......
