UM_FULL_56SL_REV_A
13
J. Turbo Timer Mode
The built in turbo timer keeps the vehicle’s engine running for either 1, 3, or 5 minutes,
after the vehicle key has been removed from the ignition. This feature will keep oil running
through the turbo system to allow for appropriate cooling time.
To activate:
Step 1:
While the vehicle is running, place the transmission in neutral, set the emergency / parking brake.
Step 2:
With your foot off the brake pedal, press buttons
+
simultaneously and the parking lights will turn on.
Remove the key from the vehicle’s ignition. The vehicle’s engine should remain running even after the key has been
removed
If the vehicle does not remain running visit your local authorized dealer for service.
Step 3:
Exit the vehicle and close the door. Press the transmitter button, the vehicle’s doors will lock/arm and then
engine will keep runs for the turbo runtime and the run time start countdown
text and tones play to confirm.
Cancelling Turbo Timer Mode:
The system will exit Turbo Timer Mode if any of the following occur:
• You did not activate the parking brake prior to turning off the ignition.
• You pressed the foot brake after the key was removed from the ignition
• You released the parking brake after the key was removed from the ignition.
• You entered valet mode, opened the vehicle’s door, hood, trunk or set off the alarm.
•
Press buttons
+
simultaneously to turn off turbo mode.
Note: Turbo Timer must be turned on by an authorized dealer.
K. Shutdown Diagnostics:
The unit has the ability to report the cause of the last shutdown of the remote start system.
Press Buttons
+
simultaneously.
4 Button Remote Transmitter:
The parking light and chirps will report the reason of the system
last shutdown by flashing in the following grouped patterns,
LCD Remote Transceiver:
The LCD display on the 2-way remote will report the reason
of the last shutdown, and the
text and a fault tone play to confirm.
Summary of Contents for 56SL
Page 1: ......
