IM_FULL_65SL_REV-A
14
FEATURE “B” PROGRAMMING
1. Turn the Ignition ‘switch
“ON/OFF” 3 TIMES
and stay in
OFF
position.
2. Push the Valet switch
4 times
(holding in on the 4th push) until a
long chirp is heard;
then release the valet switch.
You are now in the Alarm feature
“B”
programming mode.
Press and release the transmitter button corresponding to the feature you want to program.
Press
Transmitter
Button
One Chirp / LED One Pulse
Factory Default Setting
Two Chirps / LED
Two Pulses
Three Chirps / LED
Three Pulses
Four Chirps / LED
Four Pulses
1
Pathway
Illumination
Feature “OFF”
Parking Light
Turns
“ON”
for
30-Second Upon an
Unlock Signal
Parking Light Turns
“ON”
for 30-Seconds
Upon an Unlock
Signal & 10-Seconds
Upon a Lock Signal
2
Ignition Controlled Door
Locks & Unlocks
Ignition Controlled
Door Locks Only
Ignition Controlled
Door Unlocks Only
Without Ignition Controlled
Door Locks & Unlocks
3
0.8 Second Door Lock &
Unlock
3.5 Second Door
Lock & Unlock
0.8 Second Lock,
0.35 Second Unlock
0.8 Second Double Lock,
0.8 Second Double Unlock
Five Chirps
= 0.8 Second Lock, Double 0.8 Second. Unlock
Six Chirps
= Double 0.8 Second Lock, 0.8 Second Unlock
Seven Chirps
= Door Lock with “Comfort Feature”
Eight Chirps
= DBI Two-Step Unlock ( DBI ONLY )**
Nine chirps
= DBI Unlock ALL Doors ( DBI Only )**
**Select either of these options when using Two Way Data Bus Interface Only.
For use with ADS / Fortin Compatible data modules and/or Telematics Module.
4
Brown Wire = (+)
Constant Siren output
Brown Wire
=5-Second (+)
Pulse Siren Output
Brown Wire = (+)
Pulsing Output
(Relay Required for
[-] Horn)
5 +
3 Hours Timer Start
2 Hours Timer Start
6 +
The Vehicle Without
Turbo (The System
Cannot be Arm with the
Engine Running)
The Vehicle with Turbo
(The System Can be Armed with the Engine Running)
The Shock Sensor
Will Be Bypassed
Upon Engine
Running
(The Engine Will
Run by Itself After
the Ignition is
Turned
OFF
)
The Shock Sensor
Bypass Three
Minutes After Armed
(The Engine Will
Run by Itself After
the Ignition is Turned
OFF
)
Press and buttons
at the same time to control
engine run time for one
minute and the shock
sensor will be bypassed
upon
engine running.
Five chirps = Press and buttons at the same time to control engine
run time for three minutes and the shock sensor will be by-pass upon
engine running.
Six chirps = Press and buttons at the same time to control engine
run time for five minutes and the shock sensor will be by-passed upon
engine running.
7. +
Horn chirp Duration
Standard
Horn chirp Duration
50 mS
Horn chirp Duration
30 mS
Horn chirp Duration
10 mS
Exit:
Turn Ignition to
“ON”
position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.
