IM_FULL_65SL_REV-A
18
RETURN TO START FEATURE FACTORY DEFAULT SETTING:
Press the button once and then press + buttons together for 6 seconds. There will be a reset confirmation of
3 long chirps and 3 parking light flashes. Ths confirms that programmable feature settings in charts
“D”
and
“E”
are
back to their default settings.
CHECK LEVEL PROGRAMMING: (TEST AND ADJUST)
1. Press the button once on the transmitter to start the vehicle.
2. If everything goes well:
a. Press the button once on the transmitter to stop engine running. You have successfully
completed this programming.
b. Press the button on the transmitter to exit the program mode. There will be 3 long chirps & 3 parking
light flashes for confirmation.
3. If the crank time is too long, (Engine already successfully running, but still cranks):
a. Press the once on the transmitter to stop engine running or press brake pedal. Press the button on
the transmitter to set proper “Check Level ” to Low position. 1 LED flash and 1 chirp will confirm this setting.
b. Repeat steps 1 – 4 if necessary.
4. If the crank time is too short, (Engine not running, crank stopped before starting):
a. Press the button once on the transmitter to stop engine running.
Press the button on the transmitter to set proper “ Check Level ” to Hi position. 2 LED flashes and 2 chirps
will confirm this setting.
b. Repeat steps 1 – 4 if necessary.
VOLTAGE CHECKING TYPE
1. Turn the Ignition switch “
ON/OFF” 3 times
and stay in the
“OFF”
position.
Default setting
2. Push the Valet switch 7
times and hold it on the 7
th
push
until
a long chirp is hearing then release the valet switch.
3. Press the transmitter and buttons at the same time to set the “Voltage Checking Type”. 1 LED flash and
1 chirp
to confirm this setting.
Once you have completed step 3, you can adjust and test “Start Timer” as below:
START CRANK TIME PROGRAMMING
1. Press the button once on the transmitter to start the vehicle.
2. If everything goes well:
Wait for 15 seconds:
a. If the engine still running.
I. Press the button once on the transmitter to stop engine running.
You have successfully completed this programming.
II. Press the button on the transmitter to exit the program mode.
There will be 3 long chirps & 3 parking light flashes for confirmation.
b. If the engine shuts down after the vehicle has been started.
I. Press the button once on the transmitter to stop engine running.
II. Press the button on the transmitter to set “Check Level” to LOW position.
1 LED flash and 1 chirp to confirm this setting.
III. Repeat steps 1 – 2.
