IM_FULL_65SL_REV-A
8
2 STEP DOOR UNLOCK WIRE CONNECTION FOR
GROUND SWITCHED DOOR LOCKS
Cut Existing Unlock
X
Lock
Unlock
OEM Door Master Lock Switch
To All Other
Door Lock
Motors
White/Green
Wire
OEM
Door Lock
Motor
Existing Neg.
Lock Wire
Existing Neg.
Unlock Wire
86
30
85
87
87a
+ 12V
Green Wire
Door Lock
Blue Wire
Door Unlock
OEM Door
Lock Relay
22-Pin
Plug
From
Alarm
3 Pin
Plug
To
Alarm
2 STEP DOOR UNLOCK WIRE CONNECTION FOR
POSITIVE SWITCHED DOOR LOCKS
Cut Existing Unlock
X
Lock
Unlock
OEM Door Master Lock Switch
To All Other
Door Lock
Motors
White/Green
Wire
OEM Driver's
Door Lock
Motor
+ 12V
Existing Pos.
Lock Wire
Existing Pos.
Unlock Wire
30
87a
87
86
85
+12V
+ 12V
OEM Door
Lock Relay
86
30
85
87
87a
Green Wire
Door Unlock
Blue Wire Door Lock
22-Pin
Plug
From
Alarm
3 Pin
Plug
To
Alarm
4 PIN ORANGE CONNECTOR 2 STAGE SHOCK SENSOR (ZONE 1 / 4)
16 PIN ACCESSORY CONNECTOR
VIOLET WIRE – POSITIVE DOOR SWITCH SENSING INPUT (ZONE 3)–
This wire is the positive trigger input wire for positive door pin switch. This wire is connection for “positive” type
factory door pins (typical FORD MOTOR). Locate the “common wire” for all door pins and make the connection
of the VIOLET Wire here.
WHITE / VIOLET WIRE – POSITIVE SAFETY SHUT DOWN INPUT – MUST BE INSTALLED
This wire provides an instant shutdown for the remote
start, whenever it gets +12volts. If the brake lights switch
in the vehicle sw12 volts to the brake light circuit,
connect this wire to the output side of the brake switch.
This will allow the remote start to shut down if an attempt is made
to operate the vehicle without the key while running under the
control of the remote start. In most vehicles, in order to shift gear,
the brake pedal must be depressed. The brake input will in turn
cause the remote start unit to shut off. See diagram.
+12 volts from fuse box
To White/Violet
wire
Brake light bulbs
Switch closes
When brake is
depress
1
.
Green
Wire /
Zone 1
Warn Away Input
2. Blue
Wire /
Zone 4
Ground Trigger
3. Black
Wire / Ground
4. Red
Wire / +12Volts
