UM_FULL_SL51_REV_A
P R O F E S S I O N A L S E R I E S
4
DEACTIVATING WITHOUT A TRANSMITTER
OVERRIDES THE ALARM WITHOUT PASSWORD PIN CODE:
(Factory Default Setting)
The Override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to the ‘ON’ position.
2. (Alarm will sound.)
3. Within 10 seconds push and release the valet switch. The alarm will stop sounding and enter the disarm mode. You
can now start and operate the vehicle normally.
VALET MODE:
VALET MODE: (System is in Disarm Mode)
The valet switch allows you to temporarily bypass all function, eliminating the need to hand your transmitter to parking
attendants or garage mechanics. When the system is in valet mode, all functions and remote start functions are
bypassed, however, the remote panic feature and remote door locks will remain operational. To use the valet mode, the
system must first be disarmed either by using your remote transmitter, or by operating the Manual Override sequence.
Get into/out valet mode using the ignition key.
Enter Valet Mode:
a). Under disarm mode, turn the ignition to “ON/OFF/ON” position.
b). Press and hold valet switch for 2 seconds until the LED turns ON solid. The LED will remain on as long as the system
is in ‘valet mode’.
Exit Valet Mode:
a). Turn ignition ‘ON/OFF/ON’.
b). Push and hold valet switch for 2 seconds, The LED will turn off indicate the system are exiting the valet mode.
CAR LOCATOR
Under armed mode, press the button to active car locator function. The horn will chirp 6 times. The parking light will
flash 12 times, for you to easily locate your car.
PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the horn in case of emergency.
1. Press and hold the button for 3 second. The alarm will immediately sound.
2. During panic mode, the normal function of this transmitter button will be disabled. The transmitter and
buttons can be used to lock and unlock the door (if the option is installed), however once the button is pressed,
the vehicle’s starter disable device, (where installed) will be disengaged allowing the vehicle to start.
1. To stop the alarm, press the trunk button on the remote control
If the button is not pressed, the alarm will automatically stop after 30 seconds.
IGNITION CONTROL DOOR LOCK/UNLOCK. (Programmable Feature)
If the vehicles door locks have been interfaced to the security system, the system will automatically lock the vehicle’s
doors when the ignition is turned “ON” and /or unlock the vehicle’s doors when the ignition is turned “OFF”.
(Default setting is “OFF”)
TRUNK RELEASE (CHANNEL 3) OUTPUT.
Press and hold button on the transmitter for two seconds to remotely control the trunk release.
