UM_FULL_SL51_REV_A
P R O F E S S I O N A L S E R I E S
7
D. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to stop it,
1. Press button once on the remote transmitter under the remote start mode.
2. Move the optional remote start enable toggle switch to OFF position. (If installed)
3. Press the brake pedal
The vehicle will shut down and turn off the parking light to indicate the engine has stopped.
E. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the engine will not start or will shut down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. The parking (hand) brake is released (For Turbo Timer Mode)
4. Engine is over-revved. {“Tachometer checking type” only}
5. The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.
6. Press button on the remote transmitter under remote start mode.
7. The system trigger.
8. The vehicle refused to start running after {3} unsuccessful attempts.
F. DISABLING THE REMOTE START SYSTEM: (If installed)
This feature allows your system’s remote start unit to be temporarily disabled to prevent the vehicle from being remote
started accidentally. This feature is useful if the vehicle is being serviced or stored in an enclosed area. To disable the
remote start, move the optional remote start enable toggle switch to the OFF position.
TRANSMITTER PROGRAMMING
Enter:
1. Turn the Ignition ‘switch
‘OFF/ON’ 3 TIMES
and stay in
ON
position. Within 15 seconds.
2. Push the Valet switch
3 times and hold
in on the
3rd
push, when a long chirp is heard then release the valet switch.
You are now in the Transmitter programming mode.
Program:
1. Press any button on transmitter 1 until the siren responds with a confirming chirp; the first transmitter is now
programmed.
2. Press any button on the second transmitter until the siren responds with a confirming chirp; the second transmitter is
now programmed.
3. Apply the same procedure to program 3rd and 4th .Transmitters.
Exit:
Turn Ignition to ‘OFF’ position, or leave it for 15 seconds. 3 long chirps and 3 parking Light flashes will confirm exit. Note:
If more than 4 transmitters programmed, the system will only keep the last four.