Silent Guitar SLG200N, Owner'S Manual

10

Power Supply

The Silent Guitar can operate either with the power adaptor or batteries as its power source. 

Make sure that the power is switched OFF on the Silent Guitar when preparing the power supply.

  Powering with AC Current

Please purchase a power adaptor. (Compatible power adaptors: PA-3C, PA-130(A, B))

1.

  Plug the adaptor’s DC output cable into the Silent Guitar’s DC IN jack, making sure the plug is 

firmly inserted into the jack.

2.

  Plug the AC adaptor into a convenient wall AC power socket.

WARNING

  When using an AC adaptor, make sure you use only one of the following recommended adaptors (Rec

-

ommended Adaptors: PA-3C, PA-130(A, B)). The use of any other adaptor may result in damage to the 

instrument or cause fire, etc. Please use with caution.

CAUTION

  Battery power is automatically disconnected when the AC adaptor is connected. When the AC adaptor 

is used, the batteries may leak. To prevent leakage we recommend that you remove the batteries from 

the instrument. When the AC adaptor is used.

WARNING

•  Always replace both batteries at the same time. Never mix new and old batteries, battery types/models, 

or batteries from different manufacturers. Doing so can cause leakage, overheating, and rupture.

•  Do not incinerate or dismantle the battery.
•  When using NiMH batteries, take care not to damage the battery casing or poles when installing and 

removing the batteries.

•  If the battery leaks, avoid contact with the leaked fluid. If the fluid should come into contact with your 

eyes, mouth, or skin, wash immediately with water and consult a doctor.

•  Please observe all local laws, rules, etc. when disposing the batteries. 

  Using Batteries

1.

  Press the release lever in the direction 

 indicated 

on the battery case to release the lock, then pull out the 

battery holder.

2.

  Install two AA alkaline or NiMH batteries into the holder 

making sure their polarities are aligned as shown in the 

illustration inside the holder. (See illustration)

3.

  Slide the battery holder into the battery case. Push firmly 

until the case locks in place.

l

 When to Change Batteries

The triangles in the display flash alternately 

(

) when battery power becomes low. 

Change the batteries as soon as possible.

AA battery x2

Release Lever

Battery Holder