Timer point setting instructions, 1
st
time set-up
(time point A as per example 1 in
table on previous page)
Note: When setting the timer points during the programming process, moving to the next
function means the last information in the previous function is remembered.
1)
Press for 3 seconds to unlock the screen (ensure the screen unlocks before
moving to the next step) padlock symbol disappears, the no.1 appears top left.
Press for 3 seconds to enter programming mode
–
the clock symbol flashes top left of
screen.
Press once to go to timer mode (alarm clock symbol flashes top left).
2)
Press once to select timer setting programme (pre-set to timer point A) A is
flashing.
3)
Press once to move to on/off, off flashes press
to turn on.
4)
Press once to move to Channels, press
to move between channels press
to delete or reselect if deleted.
5)
Press once to go to hour (12 pre-set), press
to move hour backwards to 08.00 (press
to move forward if you overrun).
6)
Press once to go to minutes (00 pre-set), press
to move minutes forward to 30
(press
to move minutes backwards if you overrun).
7)
Press once to go to set open or close (pre-set to close), press
to set open.
8)
Press once to go to days of the week (pre-set to everyday) Sunday will flash.
9)
At this point either you have a choice - press
for 3 seconds to save the timer settings
and return to control window
OR
move forward to again by pressing
to set a further
timer point
–
A is flashing, press
to move to time point B and programme the
functions as per example 2 on table on previous page above.
Please note: during the process above on the display - = Open, = Close
Warning:
During normal use and the setting process above the timer screen will lock if the
timer is not used or no operation buttons are pressed within 30 seconds. It is now necessary
to repeat the processes in steps
1 & 2
above to re-enter the timer setting programme.
Full instructions for setting the timer are enclosed with the 11093 timer unit.
5100TC
–
Total control
