The 5100T uses each method of control Wall Plate, Handset and Timer, to assign each
please follow the steps as per the instructions above for each unit.
Trouble shooting
Possible fault
Possible cause
Solution
When plugged in the motor will
not respond
Ensure the plug is wired
correctly, check power is at the
socket outlet
When plugged in the motor will
not rotate
Re-set end limits
–
ensure limits
are retained
The motor cannot be operated
with the switch
Programme the switch to the
motor
The motor operates only for a
short distance after start up
The track has possibly been
assembled incorrectly
Check system, Re-set end limits
Buttons on timer do not
respond
(all buttons locked)
Remove battery from rear of
unit for 5 seconds, replace
battery now re
–
set clock (timer
settings are retained).
Curtains do not meet in centre
when curtains are hung.
Ensure curtain header is loose
enough to allow full movement
of the overlap arm.
