OPERATING INSTRUCTIONS
CONTROLS OF THE ICE MAKER
The ice maker should be placed where the ambient temperature is between 10-32°C (50-
90° F.) If the ambient temperature is above or below this range, the performance of the unit
may be affected.
Check the water supply
1.
Turn off water supply.
2.
Disconnect water supply line from
the ice maker.
3.
Position water supply line in a
bucket.
4.
Turn on water and make sure
water pours into the bucket.
5.
Turn water supply off again, then
reconnect the water supply line to
the ice maker.
*
If unsure, please contact your local
plumber.
Control
Type
Action
Function Explanation
Button
Button
Button
Button
Press
Press
Press
Press
To turn the ice maker
on/off (press and
hold this button for
approximately 3 seconds)
Small ice
Medium ice
Large ice
2
Single Indicator light
Single Indicator light
Single Indicator light
Single Indicator light
Simultaneous
Indicator lights
Simultaneous
Indicator lights
ON
FLASHING
ON
All on at the
same time
ON
FLASHING
ON
FLASHING
OFF
2 sizes fl ashing at the
same time for 15
seconds
Small ice is selected.
Water tank is full
and beeping. (see
troubleshooting section
page 7)
Medium ice is selected.
Large ice is selected.
Ice bucket is full of ice
Compressor on
Compressor off
Stand-by mode
Ice maker low on
water (see troubleshoot-
ing section page 7)
Sensor breakdown
(see troubleshoot-
ing section page 7)
1
2
3
Simultaneous
Indicator lights
All icons fl ashing at
the same time
System malfunction
(see troubleshooting
section page 7)
4
INDICATOR LIGHTS
