Windows XP/2000 Operating System
The driver is located on the provided floppy disk. Insert the floppy disk into the floppy disk drive and click
Browse.
Most floppy disk drives are configured as
[A:]
. Choose the
[A:]
drive in your browser and the
Si3112r.inf
file for the SiI 3112. Select the file and click
Open
:
Verify that the directly listed in this window is A: and click
OK
.
Now, a window verifying that the new Driver for the board has been properly installed. Click
Finish.
It is always good to Restart the computer after an installation.When asked to do so, Click
Yes
.
To install SATARaid, use Windows InstallShield by performing the following:
1. After computer restarts, insert cd in disk drive.
2. Double-click on
Install SATARaid.exe
.
3. Follow on-screen instructions to complete installation.
Note:
Do
NOT
install in the Start Up
folder. Choose the Default folder (normally Accessories or Administrative Tools or some-
thing similar).
Windows NT Operating System
The driver is on the provided floppy disk, insert the floppy in the floppy disk drive and click
Have Disk.
The next window is asking for the location of the driver. Most floppy disk drives are configured as
[A:]
.
To verify, click on
Browse
.
The next window verifies that the appropriate file is located on
[A:]
. Select the file
Oemsetup.inf
and
click
Open
.
[A:]
should appear in the window. Click
OK.
The next window allows you to select which driver to install. Only one driver should appear in this win-
dow. Select
SiI 3112 Raid Controller
and click on
OK
.
It is always good to Restart the computer after an installation. Click
Yes
.
2-1
SATARaid Manual - Rev. 0.92
P R E L I M I N A R Y
2. INSTALLING DRIVERS AND SOFTWARE