Rev. 0.4 1/04
Copyright © 2004 by Silicon Laboratories
AN172
A N 1 7 2
C 8 0 5 1 F 0 2
X
D
E V E L O P M E N T
K
I T
U
S E R
’
S
G
U I D E
1. Kit Contents
The C8051F02x Development Kit contains the following items:
•
C8051F020 Target Board
•
Serial Adapter (RS232 to Target Board Debug Interface Protocol Converter)
•
Silicon Laboratories IDE and Product Information CD-ROM. CD content includes:
•
Silicon Laboratories Integrated Development Environment (IDE)
•
Keil 8051 Development Tools (macro assembler, linker, evaluation ‘C’ compiler)
•
Installation Utility (SETUP.EXE)
•
Source code examples and register definition files
•
Documentation
•
AC to DC Power Adapter
•
RS232 Serial Cable
•
7” Ribbon Cable
•
Quick-start Guide
•
C8051F02x Development Kit User’s Guide (this document)
2. Hardware Setup
The target board is connected to a PC running the Silicon Laboratories IDE via the Serial Adapter as shown in
Figure 1.
1.
Connect one end of the RS232 serial cable to a Serial (COM) Port on the PC.
2.
Connect the other end of the RS232 serial cable to the DB-9 connector on the Serial Adapter.
3.
Connect the Serial Adapter to the JTAG connector on the target board with the10-pin ribbon cable.
4.
Connect the AC/DC power adapter to power jack P1 on the target board.
Serial Port
Serial
Adpater
Ribbon Cable
Target Board
AC/DC
Adapter
Serial
Cable
PC
Figure 1. Hardware Setup
Note:
The Reset switch on the target board is disabled when the serial adapter is connected to the
target board. Use the
Reset
button in the Silicon Laboratories IDE toolbar to reset the target when
connected to the Serial Adapter.
