S D B C - D K 3 U G
36
Rev. 0.3
Figure 51. Setup Screen (3 of 5)
1. Parameters on setup screen 4 are not relevant to PER evaluations. Silicon Labs recommends leaving them at
their default values.
2. Press <GO> to move on from this screen.
Figure 52. Setup Screen (4 of 5)
1. Ensure the Packet length matches that programmed in the RF signal generator.
2. Select number of packets to be received by the receiver using the Max. Packets field. The appropriate number
of triggers will be sent by the SDB according to this setting.
3. Press <GO> to move on from this screen.
Figure 53. Setup Screen (5 of 5)
1. Press <Start> to commence packet error rate evaluation.
This will start generating pulses on P1.4 that are used to trigger the RF signal generator. The RF generator will
send one packet for every external trigger. As the radio is set to receive mode it is waiting for a specific pre-
programmed packet to be arrive at the pre-programmed frequency, modulation and data rate.
Summary of Contents for C8051F930
