C 8 0 5 1 T 6 2 0 / 2 - D K
Rev. 0.5
5
6.
Click the
Connect
button in the toolbar or select
Debug
Connect
from the menu to connect to the
device.
7.
Download the project to the target by clicking the
Download
Code
button in the toolbar.
Note:
To enable automatic downloading if the program build is successful, select
Enable Automatic Con-
nect/Download after Build
in the
Project
Target Build Configuration
dialog. If errors occur during the
build process, the IDE will not attempt the download.
8.
Click on the
Go
button (green circle) in the toolbar or by selecting
Debug
Go
from the menu to start run-
ning the firmware. The LED on the target board will start blinking.
5.2.2. Creating a New Project
Use the following steps to create a new project. Once steps 1–5 in this section are complete, continue with Step 3
from Section 5.2.1.
1.
Select
Project
New Project
to open a new project and reset all configuration settings to default.
2.
Select
File
New File
to open an editor window. Create your source file(s) and save the file(s) with a rec-
ognized extension, such as .c, .h, or .asm, to enable color syntax highlighting.
3.
Right-click on “New Project” in the Project Window. Select
Add files to project
. Select files in the file
browser and click
Open
. Continue adding files until all project files have been added.
4.
For each of the files in the Project Window that you want assembled, compiled, and linked into the target
build, right-click on the file name and select
Add file to build
. Each file will be assembled or compiled as
appropriate (based on file extension) and linked into the build of the absolute object file.
Note: If a project contains a large number of files, the “Group” feature of the IDE can be used to organize.
Right-click on “New Project” in the Project Window. Select
Add Groups to project
. Add predefined groups
or add customized groups. Right-click on the group name and choose
Add file to group
. Select files to be
added. Continue adding files until all project files have been added.
5.
Save the project when finished with the debug session to preserve the current target build configuration,
editor settings, and the location of all open debug views. To save the project, select
Project
Save Proj-
ect As...
from the menu. Create a new name for the project and click on
Save
.
Not
Recommended
for
New
Designs
