C8051T63x-DK
Rev. 0.1
5
The Configuration Wizard utility helps accelerate development by automatically generating initialization source
code to configure and enable the on-chip resources needed by most design projects. In just a few steps, the wizard
creates complete startup code for a specific Silicon Laboratories MCU. The program is configurable to provide the
output in C or assembly language.
For more information, refer to the Configuration Wizard documentation. Documentation and software is available
on the kit CD and from the downloads webpage:
www.silabs.com/mcudownloads
.
4.6. Keil uVision2 and uVision3 Silicon Laboratories Drivers
As an alternative to the Silicon Laboratories IDE, the µVision debug driver allows the Keil µVision2 and µVision3
IDEs to communicate with Silicon Laboratories’ on-chip debug logic. In-system Flash memory programming
integrated into the driver allows for rapid updating of target code. The µVision2 and µVision3 IDEs can be used to
start and stop program execution, set breakpoints, check variables, inspect and modify memory contents, and
single-step through programs running on the actual target hardware.
For more information, refer to the µVision driver documentation. The documentation and software are available on
the kit CD and from the downloads webpage:
www.silabs.com/mcudownloads
.
4.7. ToolStick Terminal
The onboard debug circuitry provides both an in-system programming and debugging interface and a
communications interface to the target microcontroller's UART. The ToolStick Terminal software can access the
debug hardware's communications path and provides a terminal-like interface on the PC. Note that for concurrent
debugging and UART communications, the CP2103 USB-to-UART bridge is also included onboard.
In addition to the standard terminal functions (Send File, Receive File, Change Baud Rate), two GPIO pins on the
target microcontroller can be controlled using the terminal for either RTS/CTS handshaking or software-
configurable purposes. The ToolStick Terminal software is available on the downloads webpage:
www.silabs.com/
mcudownloads
.
Summary of Contents for C8051T630
Page 14: ...C8051T63x DK 14 Rev 0 1 8 Schematics Figure 9 C8051T630 Motherboard Schematic 1 of 2 ...
Page 15: ...C8051T63x DK Rev 0 1 15 Figure 10 C8051T630 Motherboard Schematic 2 of 2 ...
Page 16: ...C8051T63x DK 16 Rev 0 1 Figure 11 C8051T630 Emulation Daughter Board Schematic ...
Page 17: ...C8051T63x DK Rev 0 1 17 Figure 12 C8051T630 QFN 20 Daughter Board Schematic ...
