Si106x-DK
Rev. 0.2
3
3. Hardware Setup
After checking the kit contents against Tables 1 and 2, the kit can be put into operation by performing the steps
listed below.
Figure 1. Wireless Motherboard Top Markings
1. Insert a WMCU Pico Board in connectors J5, J6, J7, J8 on the Wireless Motherboard (WMB). Align the
triangle symbol on the WMCU Pico board with the triangle symbol on the WMB.
Do not connect any board
to CON1 and CON2
.
2. Connect the antenna to the SMA connector on the WMCU Pico Board.
3. Set the SUPPLY SELECT switch to USB position.
4. Set the MCU DC/DC switch to OFF position.
5. All the CURRENT MEASUREMENT jumpers (J18-J21) must be in place.
6. Start the WDS on your PC.
7. Using one of the USB cables in the kit, connect the WMB to the PC.
8. Wait for Windows to install the driver of the debug interface if necessary.
9. WDS must identify the connected board and open an Application Manager window that lists information
about the identified board.
10. Boards are shipped without preloaded software. Sample codes can be configured and downloaded to the
WMCU from WDS. For details of how to use the WDS, see the WDS User's Guides listed in "5. Useful
Documents" on page 5.
Summary of Contents for Si106 Series
Page 12: ...Si106x DK 12 Rev 0 2 Figure 6 MSC WMB912 Wireless Motherboard Schematic 2 4 ...
Page 13: ...Si106x DK Rev 0 2 13 Figure 7 MSC WMB912 Wireless Motherboard Schematic 3 4 ...
Page 14: ...Si106x DK 14 Rev 0 2 Figure 8 MSC WMB912 Wireless Motherboard Schematic 4 4 ...
Page 15: ...Si106x DK Rev 0 2 15 Figure 9 1060 PCE20C490 WMCU Pico Board Schematic ...
