Si5338-EVB
Rev. 1.4
15
D
OCUMENT
C
HANGE
L
IST
Revision 0.1 to Revision 1.0
Replaced the voltage input terminal block with
programmable regulators.
The board is entirely powered from USB power.
Added an additional LED to indicate MCU
ready.
Added jumpers on all input pins to allow
external control of features, such as output
enable, and frequency and phase increment
and decrement.
Revision 1.0 to Revision 1.1
Changed “Si533x configuration” to “Any Rate
Clock Generator” throughout.
Changed “Si5338 Programmer” to “MultiSynth
Clock Programmer” throughout.
Updated Table 1, “Programs,” on page 7.
Updated Figures 3, 4, and 8.
Revision 1.1 to Revision 1.2
Changed “Any Rate Clock Generator” to
“ClockBuilder Desktop” throughout.
Changed “MultiSynth Clock Programmer” to
“ClockBuilder Desktop” throughout.
Updated Figure 3 on page 6.
Removed “Uninstaller Option” figure.
Updated Figure 8 on page 9.
Revision 1.2 to Revision 1.3
Added "9. Bill of Materials" on page 13.
Revision 1.3 to Revision 1.4
Added "6.1. Evaluating LVPECL Output Clocks"
on page 5.
Added references to the Si5335.
