2. Ordering Information
Table 2.1. Ordering Information
Ordering Code
Protocol Stack
TX Power
Rating
Max CPU
Speed
Anten-
na
RF
Shield
Flash
(kB)
RAM
(kB)
GPIO
Temp Range
BGM220SC12WGA2
Bluetooth 5.2
0 dBm
38.4 MHz
Built-in
No
352
32
25
-40 to 85 °C
BGM220SC22HNA2
Bluetooth 5.2
• Direction Find-
ing Rx
6 dBm
76.8 MHz
Built-in
Yes
512
32
25
-40 to 105 °C
BGM220SC22WGA2
Bluetooth 5.2
6 dBm
76.8 MHz
Built-in
Yes
352
32
25
-40 to 85 °C
Note:
1. End-product manufacturers must verify that the module is configured to meet regulatory limits for each region in accordance with
the formal certification test reports.
2. Devices are pre-programmed with BGAPI UART DFU bootloader v1.10.2.
3. Throughout this document, the devices in the table above may be referred to by their product family name (e.g. BGM220S), by
model name (BGM220S12A for 0 dBm TX power, BGM220S22A for 6 dBm TX power), or by full ordering code.
4. LE Long Range (125 kbps and 500 kbps) PHYs are only supported on part numbers which include direction-finding capability.
5. In accordance with the Bluetooth specification, the module operates over the following frequency range: 2402 - 2480 MHz. The
module is also capable of operating in a separate custom transmit-only mode where proprietary packets are sent over the channels
2401 MHz and 2481 MHz using the same 1 Mbps GFSK modulation.
6. All devices in the table above support transmitting CTE (Constant Tone Extension) which is required in Direction Finding, but only
specific devices support CTE receive. These devices are marked with "Direction Finding Rx" in the Protocol Stack Column.
7. The
SLWSTK6103A Wireless Starter Kit
is available for BGM220S evaluation and development, as well as the
SLWRB4312A
radio board.
BGM220S Wireless Gecko Bluetooth
®
Module Data Sheet
Ordering Information
silabs.com
| Building a more connected world.
Rev. 1.1 | 3
