2. Kit Hardware Layout
The layout of the Wizard Gecko Wi-Fi Module Wireless Starter Kit is shown below.
WGM110
Module
Radio Board
Radio Board breakout pads
Radio Board breakout pads
1.28" Memory-LCD Display
Ultra-low power
128 x 128 pixel resolution
SPI interface
Ethernet RJ-45
J-Link Debugger
Virtual COM port
Packet Trace
Advanced Energy Monitoring
USB mini-B
J-Link Debugger
Virtual COM port
Packet Trace
Advanced Energy Monitoring
Coin Cell Holder
CR2032 Battery
Power Select Switch
BAT / USB / AEM
2x User Push Buttons
2x User LEDs Simplicity Connector
External targets:
Virtual COM port
Packet Trace
Advanced Energy Monitoring
Debug Connector
ARM Coresight 19-pin
OUT: External targets
IN: External debug probes
Reset Button
Si7021
Relative Temperature &
Humidity Sensor
EXP Header
Expansion board connector
Expansion Board
3-axis Accelerometer
2x Push Buttons
2x LEDs
Analog Joystick
I2C device footprint
microSD/SDHC card slot
On the bottom side of the Radio Board
Figure 2.1 SLWSTK6120A Hardware Layout
Note:
Some of the features and/or connections described in the above figure are not supported when using the WSTK with the
WGM110 Module. For more details see later sections in this document.
UG172: Wizard Gecko Wi-Fi® Module Wireless Starter Kit SLWSTK6120A User's Guide
Kit Hardware Layout
silabs.com
| Smart. Connected. Energy-friendly.
Rev. 1.0 | 2
