3. Run the ZigBee Gateway
After performing the steps 2.1 – 2.5 described in Section
2. Installation and Configuration
, launch a web browser and navigate to
to access the gateway functions. To power off the gateway, remove the USB power adapter.
To power on the gateway, repeat steps 2.1 – 2.3 as described in Section
2. Installation and Configuration
, then launch a web browser
to access the gateway functions.
3.1 Setup
In the Network Maintenance section of the Setup tab, confirm that “ZigBee Network: Up” is shown. On first boot the PAN ID is randomly
assigned, the channel is set to 14, and the power is set to 20 dBm. This configuration can be changed by selecting the "Reform Net-
work" configuration icon, and on subsequent boots the settings are restored. The PAN ID is a 16-bit number expressed in hexadecimal
format, the channel can be set to any valid ZigBee channel (11-26), and the valid power level range is –20 dBm to 20 dBm. Note that
range checking is enforced.
Figure 3.1. Network Maintenance
UG131: ZigBee
®
Wi-Fi/Ethernet Gateway Reference Design (RD-0001-0201) User's Guide
Run the ZigBee Gateway
silabs.com
| Smart. Connected. Energy-friendly.
Rev. 0.3 | 3
