5.2.5 ON-NETWORK State
The ON-NETWORK state is a condition where the smart outlet reference design is connected to a ZigBee network and is not searching
for another network. This state contains multiple entry and exit paths depending on various factors.
If power to the reference design is removed and later restored
, the reference design will not seek other networks unless the user forces
it to leave its joined network (as will be described within this section).
If the button is short-pressed once for more than three seconds
, the reference design will enter the LEAVE NETWORK state.
If the button is short-pressed two times
, the reference design will temporarily enter the IDENTIFY state while remaining on its joined
network.
If the button is short-pressed three times
, the reference design will temporarily enter the NETWORK STATUS state while remaining on
its joined network.
If the button is short-pressed five times
, the reference design will enter the NETWORK IDENTIFY state.
5.2.6 IDENTIFY State
The purpose of this state is to help an installer (or user) identify which device is communicated to by visually flashing the green LED in
a specified pattern to locate the targeted device. After the reference design leaves the ON-NETWORK state and enters this state, the
green LED will flash twice every two seconds for two minutes. This state is temporary, and the reference design will return to the ON-
NETWORK state once the state’s timer reaches its time limit.
5.2.7 NETWORK STATUS State
The purpose of this state is to help an installer (or user) to identify if a device is successfully connected to a network. After the reference
design leaves the ON-NETWORK state and enters this state, the green LED will flash six times in three seconds if on a network. This
state is temporary, and the reference design will return to the ON-NETWORK state.
5.2.8 SEND IDENTIFY State
The purpose of the SEND IDENTIFY state is to send an identify request to a gateway. It is then up to the gateway to react as desired to
the request.
5.2.9 LEAVE NETWORK State
Upon entering this state, the smart outlet reference design will leave the joined network and will indicate this process is in action by
flashing the green LED three times in three seconds. This state is temporary and will place the reference design into the ACTIVE
NTWK SEARCH state once the LED completes its flash sequence.
UG171: ZigBee
®
Smart Outlet Reference Design (RD-0051-0201) Kit User's Guide
Operation
silabs.com
| Smart. Connected. Energy-friendly.
Rev. 0.1 | 9
