Innovative Solar Solutions | 2917 State Hwy 7, Bainbridge, N.Y. 13733 | Ph: 800.786.0329 | www.SiliconSolar.com
3) Connect the other end of the hose to the air outlet of the pump.
4) Place the pump on a dry and safe place near the pond. The place to hold the air pump should be
higher than the water level to prevent the water from flowing back into the pump through the hose
when it is not in operation.
5) Put the two pieces of the ground spike together and mount it on the back side of the solar module with
the gland nut.
6) Mount the solar module in a sunny place by the ground spike and face the solar
panel towards the sun.
7) Insert the plug of the pump to the socket of the solar module and screw the cap
tightly.
Note: Don
’t dip the pump in water, it is not waterproof.
Note: The pump sucks in the air from the four rectangle orifices on the bottom
shown in the right photo. Please make sure the air passage is not blocked.
4. CAUTIONS
1)
Any altering of the product itself or changing of the components voids warranty.
2)
Don
’t expose small components, such as spring stone, to little kids since they may
swallow the small components and therefore be suffocated.
3)
Please lay the connection cable properly so that it will not trip people.
4)
Please mount the solar module firmly so that it will not fall down easily.
5)
Do not strike the solar panel.
5. CLEANING AND MAINTENANCE
1)
Keep the surface of the solar module clean and wipe it with soft and moist cloth when necessary.
2)
Check the spring stone from time to time and replace it with a new one if the spring stone is blocked.
6. TECHNICAL DATA
Solar module:
Capacity: 1.5 Wp
Nominal voltage: 7.68 V
Nominal current: 195 mA
Safety class: IP 65
Air pump:
Operating voltage: 6 to 9 V DC
Flow rate: max. 2 l/h
Max. air pressure: >450 mmHg
Safety class: IP 44
Cable length: 3 m
Hose length: 2 m
