<3> Steps
for the normal sample test
1) Charge LinkSquare device. It is possible to operate LinkSquare device while charging,
but it is recommended to charge the device at least an hour if the battery was totally
depleted.
2) The micro USB port does not support data transfer.
3) Press power/scan button for 5 second or more, then status indicator leds with green is
going to be blink.
4) Clink “FF00XX” or “DV00XX” on the Wi-Fi list to connect LinkSquare device (Initial
Password : “00000000”).
5) Install “LSDCTool” and run.
6) Click “New” button, and write the name of file, then “OK”.
7) Clink “Connect” button.
8) Click “Scan” button, then getting spectrum data like the figure below.
Summary of Contents for LinkSquare1
Page 3: ......
