Do not remove any of the modules components or remove the technical
specifications label.
Do not place the installation near to any possible source of inflammable
gases or vapors, since the photovoltaic modules can cause sparks just
like any other electrical component.
Always ensure the installation is equipped with protection devices against
electrical hazards.
Remember that when the modules are connected in series, the voltage
present will be the sum total of the voltage from each module, and when
the modules are connected in parallel, the current present will be the
sum total of the current from each module. This means that an installation
with various modules may contain high levels of voltage and current.
When screwing the frame of the module to the structure, avoid rubbing
against the plastic insulation on the rear surface of the module (Tedlar)
with the tool or elements protruding from the structure because this
could cause the plastic to tear, causing a loss of electrical insulation.
The PV module produces power even with a broken glass or back sheet.
Do not dispose of the module in containers or dumping sites, this can
be dangerous. If the glass or the back sheet is broken, in case of
Warnings and electrical hazards
18
Instructions for using photovoltaic modules
Summary of Contents for Photovoltaic
Page 1: ...use...
Page 12: ...11 tion Operation with the cell in the shade...
Page 43: ...Notes Instructions for using photovoltaic modules...
Page 44: ......