place of installation. A blow on the side can break the entire glass structure
that protects the modules active front.
Avoid direct contact between the glass of the PV module and the metal
of the structures parts, given that it could cause the glass to break.
Leave sufficient space between the parts and the laminates to absorb
expansions and contractions due to temperature changes.
When fastening the laminate to the support structure, do so using
Schelleter type anchor clamps with a rubber gasket or similar devices
that are suitable for laminated modules without a frame. To assure correct
installation and prevent tension in the assembly, the laminate must be
introduced on the clamp to a minimum of 8 mm and a maximum of 10
mm, and the torque applied should be between 15 and 20 Nm.
Mechanical assembly of the modules
28
Instructions for using photovoltaic modules
Summary of Contents for Photovoltaic
Page 1: ...use...
Page 12: ...11 tion Operation with the cell in the shade...
Page 43: ...Notes Instructions for using photovoltaic modules...
Page 44: ......