prevent subsequent connection. We recommend that the modules are
connected in short-circuit to avoid this.
Respect the electrical polarity of the modules. You must remember that
they are direct current modules and, as such, direct current is required
for their correct operation. In addition, when connecting the different
components of an isolated installation, you must always connect the
batteries first, followed by the module, and finally the power supply.
Do not use the connection box or the connection cables to hold or
transport the module. You could damage some of its components and
affect its waterproofness as well as the electrical security.
Always handle the module with care, even if it has the aluminium frame.
Any blow on the glass or on a corner of the frame could deform it enough
to break the glass.
Do not dismantle, modify or adapt the PV module. Do not remove any
part or the identification label from a PV module installed by Siliken
Modules S.L.U. If you do so, the guarantee will be invalid. Do not apply
paint or adhesives to the back side of the PV module.
WARNING: SILIKEN shall not be held responsible or liable for any
possible decrease in the electricity production of the photovoltaic
module supplied, nor shall it consider said reduction to be a
manufacturing defect if it is the result of the failure to observe the
recommendations for use described herein.
!
Recommendations for use
7
Instructions for using photovoltaic modules
Summary of Contents for Photovoltaic
Page 1: ...use...
Page 12: ...11 tion Operation with the cell in the shade...
Page 43: ...Notes Instructions for using photovoltaic modules...
Page 44: ......
