EN
EN
12
a
The device is set to switch off automatically after 1 minute. However, if
you change modes during a treatment, the timer will reset to zero and
will start again.
7. Cleaning and maintenance
Use warm water up to a maximum of 45ºC / 113º F.
7.1 Cleaning the brush heads
Clean the
brush head
after each use.
U
Switch the device off. Rinse with warm water and mild soap to remove
any build-up that may have accumulated. Then shake off any excess
water.
U
Dry the brush and the
brush head
with a towel. You can also dry the
brush head
by switching the device back on, and rubbing it against a
towel for 5-10 seconds.
a
We recommend you replace used
brush heads
every 3 months, or earlier
if you see that they are worn.
C
Do not allow face wash to accumulate on the
brush heads
.
7.2 Cleaning the device and charging cradle
We recommend that you clean the device after each use, and the
stand/
charging cradle
once a month. Before cleaning:
U
Remove the device from the
stand/charging cradl
e.
U
Disconnect the
stand/charging cradle
from the electricity supply.
U
Do not use abrasive cleaners or chemicals to clean any parts.
U
Clean the device or
stand/charging cradle
with a damp cloth using a mild
detergent, then wipe it dry with a clean cloth.
U
To remove any residue of face wash around the
nipple
, remove the
brush head,
and wash the
nipple
and the surrounding area with warm
water. Then wipe it dry with a clean cloth.
C
Do not clean the device or any of its parts in the dishwasher.
Fresh UM EU124 2848B inside ALL ED225-05 spaces.indd 12
12/11/2017 08:42:00
Summary of Contents for Fresh H4001
Page 2: ...1 1 6 6 3 3 2 2 4 4 5 5 8 8 7 7 9 9 ...
Page 123: ......
