12
Energy Level
Energy level determines the intensity of the Silk’n SensEpil™ light pulse delivered to your skin, from the lowest level (-) to the highest level (+).
Corresponding
INDICATOR LIGHTS
on the
CONTROL PANEL
represent the increases in energy. As energy level increases, so does hair removal
results as well as the risk of possible side effects and complications.
Always start your first Silk’n SensEpil™ hair removal session at the lowest energy setting.
If you experience little or no discomfort during and after the hair removal session using the lowest energy level, raise the energy level by one
INDICATOR LIGHT
at the next session, and so on for each subsequent session.
Whenever Silk’n SensEpil™ is turned on its energy level will automatically be reset to the lowest energy level. Only one
ENERGY LEVEL INDICATOR
LIGHT
will be on.
To set the energy level, press the
ENERGY LEVEL SETTING BUTTONS
using “-“ or “+” to respectively decrease or increase the energy level. The
number of
ENERGY LEVEL INDICATOR LIGHTS
will coincide with the change in energy level.
For your safety, when using Silk’n™ SensEpil for the very first time, the system is automatically set to deliver the first 50 pulses at the lowest energy
level, and the next 200 pulses at up to level 3.
To cancel these safety settings press and hold the “+” and ”-“
ENERGY LEVEL SETTING BUTTONS
simultaneously until you hear 2 consecutive
“beep” sounds.
To restore these safety settings press and hold the “+” and ”-“
ENERGY LEVEL SETTING BUTTONS
simultaneously until you hear 3 consecutive
“beep” sounds.
Do not raise the energy level if you experience abnormal discomfort during or after treating with Silk’n SensEpil™!
(See “Possible Side Effects”)
Do not raise the energy level during hair removal session even if you experience no discomfort. Discomfort may also appear
some time after the session.
Try to avoid overlapping pulses!
Do not treat the same area of skin more than once per hair removal session!
The Skin Color Sensor
Light-based hair removal on darker skin tones can result in adverse effects such as burns, blisters, and skin color changes (hyper- or hypo-pigmentation).
To prevent such misuse, a unique
SKIN COLOR SENSOR
in Silk’n SensEpil™ measures the treated skin complexion at the beginning of each session
and occasionally during the session. If the
SKIN COLOR SENSOR
detects a skin tone that is too dark for Silk’n SensEpil™ application, the device will
automatically stop emitting pulses.
If you see no light pulse and the
SKIN TONE WARNING INDICATOR LIGHT
blink for 3 seconds, this is an indication that your skin tone, measured by the
SKIN COLOR SENSOR
, is too dark for safe application. Try using the device on a different body part or contact the Silk’n SensEpil™ support.
Covering skin areas
Silk’n SensEpil™ pulses should be administered in rows, starting at one end of each row and progressing sequentially
towards the other end. This technique allows better control of skin coverage, and helps you avoid treating the same area
more than once or overlapping skin areas.
When applied to the skin, the Silk’n SensEpil™
APPLICATOR TIP
is designed to create temporary pressure marks on the
treated area. These visible marks can be used for proper positioning of the next pulse.
Summary of Contents for sensepil AS101028A
Page 1: ...1 INSTRUCTIONS FOR USE ...
