I. Installing the Thermo Stabilizer
®
1. Ensure that the main switch to the device you wish to control
is off.
2. Cut the wire going to the device and strip a small piece of the
insulation plastic from all the wires. No wire should be exposed.
3. Unscrew the plastic cover and push the wire coming from the
mains (110V ~ 230V) through the centre gland and the wire
going to the Thermo Stabilizer
®
to the output A terminal and tighten
the screws.
4. Remove your current thermal couple from your water heater and
replace it with the supplied Silux
©
thermal couple. Push the
connector coming from the Silux
©
thermal couple through the small
gland and plug it into the socket on the Thermo Stabilizer
©
.
*Please Note: The thermal couple is necessary to get live
temperature readings and keep the water at the selected
temperature.
5. Tighten all the glands and screw the plastic cover back on
again. You can mount the Thermo Stabilizer
®
to a desired location
using the mounting holes on the side of the Thermo Stabilizer
®
with
the supplied plugs and screws.
6. Turn the main switch to this device on. The RED light on the
front of the device will switch on. This means the Thermo
Stabilizer
®
has power.
*Please Note: There is a green light for output A and a green
light for output B of the Thermo Stabalizer
®
which switches on
to show the corresponding devices is on.
II. Replacing the CR2032 3V battery
There will be one CR2032 battery included with the product. This
battery is used to keep time and date as well as schedules in case of
power disruptions.The battery will have a life span of up to 1-2 years,
depending on how the Thermo Stabilizer
®
is used.
We recomend switching the Thermo Stabilizer
®
’s power off before
changing the battery.