japa
315+
User manual
Translation
24
315+ 2.0 - 2020
5.4 Monthly maintenance (200 hrs)
The 200 hr maintenance is intended to be performed between long work periods, roughly after every
20–30 days of use. Clean the machine and check the adjustments to prevent any problems from
occurring.
A. Detach safety rod and three 13 mm screws in
the cover and lift the cover open. Ensure that the
locking plate moves into the locking position.
B. Clear debris and other impurities from inside the
machine, particularly from the pusher groove.
C. Check the adjustments of the saw valve and
return spring. Tighten the return spring and adjust
the stop screw as necessary (5.4.1).
D. Remove impurities from the bottom groove of
the conveyor and the drive roller at the bottom
end. Tighten the conveyor belt if necessary
(2.4.M).
F. Check the oil level of the multiplier gear (TR
models only) A. breather cap, B. inspection plug,
C. draining plug
A
B
C
