background image

 

 

 

 

 

 WARNINGS   

 

This  sprayer  is  designed  and  manufactured  solely  for  the  purpose  of  applying 
agricultural chemicals. Under no circumstances may it be used for any other purpose. 

 

Read owner’s manual completely before operating this sprayer.

 

 

Test the sprayer with water before using chemicals 

 

Before  using  chemicals  refer  to  the  chemical  manufacturer’s  label  and  safety 

instructions  for  safe  handling  procedures  and  recommended  personal  protective 
clothing and safety equipment. 

 

Never use flammable liquids, caustics, acids, or hot water in this tank. 

 

Do not use sprayer near open flame or anything that could cause ignition of the spray. 

 

Do not leave sprayer in the sun when not in use. 

 

Spray when the air is calm to prevent drift of chemicals. Do not spray in windy conditions. 

 

Always inspect hose and all the hose connections before each use. A damaged hose, or 
loose hose connection can result in unintended exposure to the pressurised chemical, 
resulting in serious injury or property damage. 

 

Do not lift or carry sprayer by the hose, shut-off valve, or wand extension. Carry by the 
handle only. 

 

Do not pressurise with any mechanical device such as an air compressor, since this can 
create a dangerous pressure level and bursting of parts resulting in serious injury. Only 
use original pump. 

 

Do not store chemicals in this tank. 

 

Always  release  pressure  when  sprayer  is  not  in  use  and  before  performing  any 
maintenance. 

 

Clean and rinse sprayer thoroughly after each use and before and maintenance. 

 

Never attempt to alter sprayer from original condition. 

 

Exercise care to ensure proper stability when carrying or operating in hilly or uneven 
terrain, particularly if the ground is wet or loose. Wear non-slip shoes 

 

Keep the sprayer and all chemicals out of the reach of children. 

If  you  experience  problems  or  have  questions  in  Australia,  please  contact  our  toll-free 
Customer Service Centre at 1300 745826, or email: info@silvanaust.com, or access online 
at: 

www.silvan.com.au

 

In New Zealand phone 0508 745826 or email: infonz@silvanaust.com 

WARRANTY: This product is warranted to be free from defects in materials and workmanship for the warranty period of 5 
years from the date of retail sale. In the event of failure return the goods to the place of purchase at your cost and within 
the warranty period along with evidence of the purchase date. If the fault is assessed to be a failure due to faulty materials 
or manufacturing, then the product will be repaired or replaced without charge for labour or any defective parts. If the 
original supplier cannot be contacted, then contact Silvan and we can direct you on how to proceed with your warranty 
claim. Our goods come with guarantees that cannot be excluded under the Australian & New Zealand Consumer Law.  

 

 

Safety Instructions 

Summary of Contents for 190545










Reviews: