4
Filling:
IMPORTANT: Always make sure the pressure is released from the tank before filling or
servicing.
1. Pull up on the knob of the pressure release valve until all the pressure is released from
the tank. (
See Figure E
).
2. Turn the pump handle counterclockwise to remove the pump (
See Figure F
).
3. Fill the tank to the desired level. See fill markings on side of tank. (Always refer to chemical
manufacturer for proper mixture).
4. Install the pump into the tank opening and turn clockwise until tightly sealed against the
tank (
See Figure G
).
Figure E Figure F Figure G
Pressurising:
1. Make sure spray gun shut-off lock is not on. (If shut-off lock is on while pressurising, the
unit will immediately start spraying).
2. Push down on the handle and turn counter clockwise to unlock the handle (
See Figure-
1H
).
3. Pressurise the sprayer by pumping the handle in a smooth up and down motion (
See
Figure-2H
).
4. Push down on the handle and turn clockwise to lock the handle into the pump (
See
Figure-3H
).
Figure 1H Figure 2H Figure 3H
Operation
