Do not exceed the vehicle manufacturer’s specified safe load and carrying capacity.
SETTING UP YOUR SPOTPAK
The hose is supplied fitted at one end to the spray lance.
Fit the white elbow fitting to the outlet of the pump and finger tighten.
FITTING INSTRUCTIONS
Position the sprayer so as to minimise contamination to the operator. With the pump mounted away from operator the
risk of contamination due to hose failure can be minimised. It is recommended that the sprayer be securely attached to
any ATV or other vehicle. Refer to manufacturer’s instructions for appropriate load limits and fitting positions.
Note : 1 litre of water = 1 kg.
Never fill spray tank to a capacity beyond the specified overall weight limits set by your vehicle manufacturer. Recesses
in the top of the tank allow for tie down straps. When fitted these should be firmly secured to approved attachment
points on the ATV or other vehicle.
The sprayer should be mounted centrally and as near to the centre of gravity of the ATV as possible. It should not
protrude so as to cause an obstruction.
CONNECT GUN AND TRIGGER
For 50L spotpak sprayer, there is a gasket which
should fit between lance and trigger. The small
side is positioned face to trigger.
SPRAY LANCE HOLDER
Supplied with the Spotpak is a pair of clips for holding the
Spray lance to the tank for easy storage and transport. To fit
orientate the clip as shown and pres to the locating lug in the
tank. Below the Lug is a threaded brass insert embedded in
the tank; attach the provided screw to tank using a phillips
head screwdriver.
Installation