6
FILLING THE TANK AND ADDING CHEMICAL:
Warning:
Before using the sprayer for the first time or adding chemical check the operation and
function of the sprayer with clean water
Check that the battery is charged, the filters are clean, and all fittings, hoses and gun connections
are tight.
Partly fill the sprayer before adding chemical. Always use clean water to prevent blockages and
ensure chemical function is not inhibited.
Add the chemical according to the directions on the chemical container following all safety and
protective equipment recommendations.
Do not use
wet powders or chemicals that must remain suspended in solution and require agitation.
Only use chemicals or dyes that fully dissolve.
Do not use
a sprayer that has been used to spray herbicides for insecticides or nutrients unless the
sprayer has been thoroughly cleaned including neutralizing the herbicide according to the
manufacture
r’s
directions if required.
INSTALLING BATTERY PACK:
1.
Push in lock tab
2.
Slide cover down
–
then install battery in socket
3.
Push in lock tab on the battery to pull it out of socket
Operation
1
2
3
3