Silver King SKFSM, Technical Manual And Replacement Parts List

 2 

INSTALLATION

The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping.  This covering 
can be readily stripped before installation.  After removing this covering, wash the interior and exterior surfaces using a warm, mild 
soapy water solution and a sponge or cloth, rinse with clean water and dry. 
 

Shelves

Inside the unit you will find A Shelf and a plastic bag containing Shelf Supports.  This shelf system allows for easy adjustment to suit 
your needs. 
 

Door Adjustment and Swing

Should the Door ever require straightening, loosen the Screws on the Hinges, square the Door with the cabinet and retighten the 
Screws. 
 
The mounting of the Door is easily reversible on single door units should space or convenience require that you do so.  Simply remove 
the Screws holding the Hinges, rotate the Door 180 degrees and relocate the Hinges on the side opposite their original location. 
 

Location

When locating your new refrigerator, convenience and accessibility are important considerations, but the following installation 
guidelines must be followed; 
 



  Always avoid placing the refrigerator adjacent to an oven, heating element or hot air source that would affect the operation of the 

unit. 



  For proper ventilation the unit requires the following minimum clearances: 

-4 inches in back 
-2 inches on the sides and 2 inches above the cabinet 



  The unit must be level or tilted backwards slightly. 

Energy Rating 

Your Silver King refrigerator has a class 5 energy rating.  The refrigerator was tested at an ambient temperature of 40°C at 40% relative 
humidity.