1
TECHNICAL MANUAL
SILVER KING FRONT BREATHING REFRIGERATORS
MODELS SKRB27 AND SKRB27D
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the
most reliable equipment in the industry today. Please read this manual and the accompanying warranty
information before operating your new Silver King unit. Be sure to complete and mail the warranty card
within 10 days of purchase to validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to examine and test for possible damage
following the instructions printed on the exterior of the container. Report any damages to the carrier re-
sponsible for transportation and promptly present a claim for any evidence of mishandling. Save all pack-
aging materials if a claim must be filed.
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing
and shipping. This covering can be readily stripped before installation. After removing this covering, wash
the interior and exterior surfaces using a warm, mild soapy water solution and a sponge or soft cloth. Rinse
afterward with clean water and wipe dry.
Location
When locating your new Silver King unit, convenience and accessibility are important considerations, but
the following installation guidelines must be observed;
* Always avoid locating the unit adjacent to an oven, heating element or hot air source which could ad-
versely affect the performance of the unit.
* If the unit is not on casters, it is designed to be sealed to the floor with a waterproof sealant as required by
NSF International. To do so, locate the unit in its desired location (following the installation instructions),
apply a bead of sealant around the perimeter of the unit at the base and smooth out with a finger to form a
radius with the floor and the unit.
* The unit must be level.
* For proper ventilation, the bottom front of the unit must not be obstructed.
Shelves
Inside the unit you will find Shelves and a plastic bag containing Shelf Supports. The Shelf Supports with
the tang go on the rear Pilasters. This shelf system allows for easy adjustment to suit your needs.
Drawers
To remove the Drawers on the drawer models for cleaning, simply open them fully, push the stop levers out
of the way on the Cabinet Drawer Tracks while pulling the Drawer out. To reinstall the Drawer, line up the
Drawer Tracks on the cabinet and the Drawer and push the Drawer into the cabinet. The Drawer Pan can
be removed by lifting it out with the Drawer extended.
All manuals and user guides at all-guides.com
