8
SDBE 2600 A1
GB
IE
After use
■
Remove the power plug from the mains power
socket.
■
Empty the water tank and clean the sole of the
iron
0
.
■
Place the cooled-down steam iron on the base
9
.
Drip-Stop function
With conventional steam irons, water can drip from
the sole of the iron
0
at low temperatures.
This iron, however, possesses a new feature: the
DRIP-STOP function. At low temperatures the iron
automatically switches off the steam-blast function.
Then set a suitable temperature with the tempera-
ture control
6
. As soon as this is reached, steam
production is resumed.
Automatic switch-off
This steam iron is fi tted with an automatic switch-off
system. This stops the iron from heating up.
If the iron is resting on its sole
0
and is not moved
for about 30 seconds, there will be a warning beep
and the control lamp for the automatic switch-off
7
fl ashes. The iron will stop heating up. To deactivate
the automatic switch-off , lift up the iron and move
it gently from side to side. The control lamp for the
automatic switch-off
7
goes out and the iron will
heat up again.
If the iron is resting on its base
9
and is not moved
for about 8 seconds, there will be a warning beep
and the control lamp for the automatic switch-off
7
fl ashes. The iron will stop heating up. To deactivate
the automatic switch-off , lift up the iron and move
it gently from side to side. The control lamp for the
automatic switch-off
7
goes out and the iron will
heat up again.
NOTE
The automatic switch-off is not intended as a
substitute for removing the plug from the mains
power! This is merely intended to reduce the fi re
hazard if you forget to switch of the iron!
Cleaning
Self-cleaning function
■
Fill the water tank to the "MAX" marking.
■
Insert the plug into the mains power socket.
■
Move the temperature control
6
to the "MAX"
position.
■
Set the steam control
3
to maximum steam
power.
■
Allow the steam iron to heat up until the heat
control lamp
7
goes out and then lights up
again.
■
Hold the steam iron horizontally over a suitable
container.
■
Press and hold down the self-clean button
q
.
Move the steam iron back and forth a little.
Steam and boiling water will fl ow from the
steam exit holes in the sole of the iron
0
. Any
impurities that may be present are fl ushed out.
■
Release the self-clean button
q
as soon as all
of the water has fl own out of the water tank.
IB_114193_SDBE2600A1_SE_NL.indb 8
09.07.15 16:00
Summary of Contents for 114193
Page 5: ...A B ...
