51
GB
7.1 Filling the water tank
DANGER!
~
Pull the mains plug out of the socket be-
fore you fill up the water tank
16
.
• Use clean tap water without any addi-
tives (e.g. vinegar, limescale remover,
starch, perfume, softener).
• The integrated anti-limescale protection
reduces limescale deposits for average
water hardness, and thus extends the
service life of the device. If your tap wa-
ter is hard, use distilled water. Where
the water is moderately hard, mix dis-
tilled water and tap water at a ratio of
1:1.
1. Disconnect the mains plug from the wall
socket.
2. Set the steam flow rate controller
5
to
.
3. The switch
11
is in the top position
. Remove the steam iron from the
stand
12
. The cable base
10
remains
in the stand.
4. Open the lid
2
(of the water tank) and
hold the device at an angle to fill it.
5. Use the measuring beaker
22
to pour in
water up to the mark
21 max,
but at
least up to one quarter. Hold the steam
iron upright to check.
6. Close the lid
2
(of the water tank).
7. Place the steam iron on the stand
12
and set the steam flow rate controller
5
to the desired position.
7.2 Set iron temperature
NOTE:
• The steam iron must be connected to the
cable base in order to heat up.
1.
Figure D:
Set the desired temperature
using the temperature controller
19
:
-
MIN
the device is not getting hot
-
÷
Temperature: up to approx.
110 °C
-
÷÷
Temperature: up to approx.
150 °C
-
÷÷÷
Temperature: up to approx.
210 °C
-
MAX
maximum temperature:
2. The temperature control lamp
14
is lit
for as long as the steam iron is heating.
It goes out when the set temperature has
been reached. You can then begin iron-
ing.
7.3 Spray function
Use the spray function in order to dampen
dry items of laundry. This option is available
irrespective of the set temperature. For this
purpose, the water tank
16
must be at least
one quarter full.
• Press the spray button
3
repeatedly.
While doing so, hold the steam iron
over the item of laundry. Ensure that no
water sprays onto the ground.
B&3(B'DPSIEJHOHLVHQB%ERRN6HLWH0LWWZRFK-XOL
