50 GB
4. Items supplied
1 Fan heater
1 Remote control
|
19
1 Button cell CR2032
1 Operating instructions
5. How to use
5.1 Setting up the device
NOTE:
some parts of the device might be
slightly greased when delivered, which is
why
slight
smoke and odour formation
might develop. This is harmless and stops af-
ter a short amount of time. Ensure sufficient
ventilation in the meantime.
1. Remove the device from the packaging.
2. Remove any transport packaging and
any protective foil present.
NOTE:
there is a piece of corrugated board
between the device and base
|
3
, which also
needs to be removed.
3. Check that the device shows no dam-
age.
FIRE HAZARD!
~
Ensure that there is sufficient distance to
the wall, furniture and fixtures or other
devices. The distance should be at least
0.5 m, in order to exclude the risk of a
fire hazard.
4. Select a location which complies with
the safety information.
5. Select a location where people, animals
or plants will not be suddenly hit by the
hot air flow.
6. Insert the mains plug into a wall socket
corresponding to the technical data.
NOTE:
the device requires up to 10 amps
electricity (2,000 watt). If you have connect-
ed other consumers in the same electric cir-
cuit, ensure that the maximum capacity of
the fuse is not exceeded, as the fuse will oth-
erwise trigger.
5.2 Inserting the battery
If the device is new or if the battery in the re-
mote control
|
19
is empty, a new battery of
the type CR2032 must be inserted.
1.
Figure A:
press the closing flap to-
wards the centre and pull the battery
compartment out.
2. Remove the old battery, if applicable.
3. Insert a new battery.
NOTE:
be sure to observe the correct polar-
ity when inserting the battery (+/–).
4. Slide the battery compartment back in.
BB&3(B%ERRN6HLWH)UHLWDJ)HEUXDU
